Views: 0 Author: Site Editor Publish Time: 2022-07-15 Origin: Site
With the development of urban industrialization, the air quality is getting worse and worse. People began to buy air purification equipment to improve the indoor air quality. However, there are many kinds of duct fans on the market. How to choose the right duct fan?
What are the common problems and precautions in the installation and design of duct fans?
What are the operating conditions of the duct fan?
What should be paid attention to when installing the duct fan?
Division of ventilation systems. Some factories are often uniformly divided into one system for their own personal gain or convenience. They not only fail to achieve good ventilation, but also create hidden safety hazards for the operation of the factory. When the industrial area is wide and multiple exhaust points are placed, a unified management system can be designed to form a whole with the duct fan and multiple exhaust points. The division of the system can be combined with the nature, process, time, operating parameters of industrial production, and requirements for air, humidity, and temperature. The same or similar gases can be divided into one system for unified management. Two kinds of gases that are easy to mix and will produce more toxic gases or easily cause fire and explosion should not be divided into one system, but an independent ventilation system should be designed.
1. The inlet steam temperature of the medium conveyed by the duct fan should generally not be greater than 40 °C.
2. The content of particles in the medium should not exceed 100mg/m3, and the large size of the particles should not exceed half of the small work gap.
3. During operation, the bearing temperature should not be higher than 95℃, and the lubricating oil temperature should not be higher than 65℃.
4. The operating pressure shall not be higher than the boost range specified on the nameplate.
5. When the duct fan is running, the oil level of the main oil tank and the auxiliary oil tank must be between the two red lines of the oil level gauge.
a. If heat removal or heat removal is required, the roof duct fan should be set first as much as possible;
b. When heating, cooling or fresh air needs to be supplied, the warm air or cold air should flow through the location of the staff as much as possible, so more duct fans or side wall fans are used;
c. For firefighting and smoke exhaust, roof fans or hoisting air ducts should be used first, so duct fans are often used;
d. Make use of natural air flow as much as possible (the location and form of the fan should be set reasonably).
Guangzhou Meihao HVAC Equipment Co. Ltd., which has been established for over ten years, focuses on the production of duct fans. Here, you can find the duct fans you need.
NO.C105 Yuewang building, NO.1 Wangling section of 106 national road, Baiyun district
020-81982207